interface tenGigabitEthernet
■
Use to select a 10-Gigabit Ethernet interface on the E120 router or the E320
router.
NOTE:
On the ES2-S2 10GE PR IOA, you can configure only the primary port, 0. The
router automatically uses the redundant port, 0R, if the primary port fails.
■
Use the
slot/adapter/port
format.
■
Example—Selects a 10-Gigabit Ethernet interface on the ES2-S1 10GE IOA
host1(config)#
interface tenGigabitEthernet 4/0/1
■
Use the
no
version to remove IP from an interface. You must issue the
no
version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
■
See interface tenGigabitEthernet.
ip mac-validate
■
Use to enable or disable MAC address validation on a per interface basis.
■
Use the
strict
keyword to prevent transmission of IP packets that do not reside
in the validation table.
■
Use the
loose
keyword to enable IP packets to pass through even though the
packets do not have entries in the validation table. Only packets that have
matching IP–MAC pair entries in the table are validated.
■
The default behavior is not to perform MAC address validation.
■
Example
host1(config)#
interface gigabitEthernet 2/0
host1(config-if)#
ip address 4.4.4.2 255.255.255.0
host1(config-if)#
ip mac-validate strict
host1(config-if)#
exit
■
Use the
no
version to disable the command.
NOTE:
For additional information about MAC address validation, see the
arp validate
command description in
JUNOSe IP, IPv6, and IGP Configuration Guide
.
■
See ip mac-validate.
load-interval
■
Use to set the time interval at which the router calculates bit and packet rate
counters.
■
This command does not work for the Fast Ethernet port on the SRP module.
■
Specify a multiple of 30 seconds, in the range 30–300 seconds.
Configuring the Physical Interface
■
199
Chapter 5: Configuring Ethernet Interfaces
Содержание JUNOSE 10.0.X PHYSICAL LAYER
