Juniper JUNOSE 10.0.X PHYSICAL LAYER, Руководство по настройке

Страница: 44 / 262

host1(config-controll)# t1 1 fdl string port 0800
host1(config-controll)# t1 1 fdl string generator "Test generator"
5.
Enable transmission of FDL messages.
host1(config-controll)# t1 1 fdl transmit path-id
6.
(Optional) Specify that the router should generate yellow alarms for the T1
channels.
host1(config-controll)# t1 1 yellow generate
7.
(Optional) Specify that the router should detect yellow alarms for the T1 channels.
host1(config-controll)# t1 1 yellow detect
t1 fdl
■
Use to specify the FDL standard for the channel.
■
Specify one or more T1 channels or a range of channels in the range 1–28.
■
Specify the keyword ansi to support the ANSI FDL standard (see “References”
on page 9).
■
Specify the keyword att to support the AT&T FDL standard (see “References”
on page 9).
■
Specify the keyword all to support both the ANSI and AT&T standards
■
Specify the keyword none to remove the current FDL mode settings
■
You can configure a different standard on each T1 channel.
■
Example
host1(config-controll)# t1 14-20,24 fdl att
■
Use the no version to restore the default, none.
■
See t1 fdl.
t1 fdl carrier
■
Use to specify that T1 channels are used in the carrier environment.
■
Example
host1(config-controll)# t1 6 fdl carrier
■
Use the no version to restore the default situation, in which the T1 channels do
not operate in the carrier environment.
■
See t1 fdl carrier.
t1 fdl string
18 ■
Configuration Tasks
JUNOSe 10.0.x Physical Layer Configuration Guide