Jungheinrich ERE 120, Руководство по эксплуатации

Страница: 63 / 179

02.15 EN
62
3.2 Preparing the truck for operation
Switching on the truck
Requirements
– For checks and operations to be performed before starting daily operation, see
"Checks and Operations to Be Performed Before Starting Daily Work" on page 61.
Procedure
• For rider mode, fold out the operator platform (10) and the side arms (
o
) (11).
• For rider mode, step on the operator platform.
• Pull out the emergency disconnect switch (8) until it engages.
• Switch on the truck, to do this
• Insert the key in the key switch (56) and turn it as far to the right as it will go.
• Enter the code in CanCode (
o
) (54).
• Hold the card or transponder in front of the ISM access module and, depending
on the setting, press the green button on the ISM access module (
o
).
Z
For trucks with a folding platform the tiller (6) must be in the upper brake position
"B". If event message "E-0914" is displayed in the CanDis display instrument
(
o
), move the tiller to the upper brake zone "B", see "Travel" on page 72.
Truck is operational.
t
The battery discharge indicator (52) shows the current battery charge status.
o
The CanDis display instrument (9) indicates the available battery capacity and the
service hours.
WARNING!
Accidental truck movement can cause injury
Do not press the travel switch when entering or leaving the operator platform.