JUMO Wtrans E01, Руководство по эксплуатации

Страница: 55 / 64

55
10 Setup program
The current transmitter parameters are imported to the setup program.
10.4.3 Editing the transmitter parameters
1. In the navigation tree, select the transmitter data record to be edited by left-clicking it twice.
The "Transmitter configuration" is opened.
2. Edit the desired parameters.
3. Exit the editing procedure with "OK".
4. Save the parameters in the "File" menu with the "Save" function.
10.4.4 Transferring new parameters to the transmitter
1. Select the desired transmitter data record (1 to 16) from the left of the navigation tree.
2. In the "Data transfer" menu, select the "Data transfer to device" function.
The current parameters are transmitted to the transmitter.
3. End the communication between the setup program and transmitter in the "Data transfer" menu us-
ing the "Disconnect connection" function.
NOTE!
At a transmission interval of > 30 s, the transmitter transmits a link telegram (not after a change in the
setup program, but after the device is started), i.e. the telegrams are transmitted at an interval of 30 s for
a period of 30 minutes, and only then at the set transmission interval.
NOTE!
If the setup plug is connected, the probe automatically transmits telegrams with a transmission interval
of 1 s to enable the receiver to detect changes immediately. After the setup connector is removed, the
telegrams are transmitted again at the set transmission interval.
NOTE!
If the device is in the startup level, then it proceeds as if the USB connector had been inserted (trans-
mission interval 1 s).
NOTE!
If the configuration has been closed at the USB interface, seal the opening on the device using the sup-
plied sealing screw M12 × 1.5 (accessories set) with the help of the mounting key (accessories set).