JUMO Wtrans E01, Руководство по эксплуатации

Страница: 48 / 64

9 Configuring the transmitter
48
9.2.2 General parameters
NOTE!
Default settings are shown in bold .
Recommended procedure:
1. Enter the desired settings/values in the right-hand column of the following tables.
2. Individually select and edit the parameters one after the other.
This is the only way to ensure parameter entry within the default key timeout of 40 s, after the elapse
of which the measuring probe automatically returns to the normal display.
The selections/settings carried out so far remain unchanged.
Device data
9.2.3 Measured value-specific parameters
NOTE!
Default settings are shown in bold .
Recommended procedure:
1. Enter the desired settings/values in the right-hand column of the following tables.
2. Individually select and edit the parameters one after the other.
This is the only way to ensure parameter entry within the default key timeout of 40 s, after the elapse
of which the measuring probe automatically returns to the normal display.
The selections/settings carried out so far remain unchanged.
Parameter Display Value range/selection 
Software version UErS 0 to 99.99
Display only, cannot be edited
Customer ID Id 0 to 9999
Transmission interval Int 1 (15) to 3600 s
Radio frequency FrEq 868.4 MHz
Display only, cannot be edited
Switch on LCD display
Switch off LCD display diSP on
oFF
LCD display
Backlight
Switch on
Backlight
Switch off LigH
on
oFF
Cyclical measured value display
Switch on
Cyclical measured value display
Switch off AUto
on
oFF
Temperature unit
(Display on the transmitter) Unit °C (degrees Celsius)
°F (degrees Fahrenheit)
Code for parameter level CodE 0 to 9999
No code request at 0
Battery type
Lithium
Alkaline bAt
LI
AL