JRC JAN-701B -, Инструкция по эксплуатации, Страница: 188 / 564

3 Basic Operation of ECDIS 3-126
3) Determine the angle of the cross bearing line by turning the [EBL] dial or entering the reciprocal
bearing viewed from the reference point.
Bearing from the reference point is displayed in the 180 degree reciprocal bearing with typing in
value.
4) Determine the distance of the cross bearing line by turning the [VRM] dial or entering the
distance.
Setting range is 0.0NM - 99.9NM.
5) The drawing of the cross bearing line is determine by left-clicking the [Set], and the bearing is
displayed beside the cross bearing line.
6) The cross bearing display is switched by left-clicking the [True] radio button or the [Reverse]
radio button.
[True] display
[Reverse] display
7) To display more than one bearing line, repeat steps 1) to 4). Up to ten bearing lines can be
displayed at the same time.
8) To clear all the displayed cross bearings, left-clicking [Clear].
9) To close the“Cross Bearing” panel, left-click the [Close].