Johnson & Johnson Surgical Vision Veritas, Руководство оператора

Страница: 55 / 270

Z370584 Rev. D
4-1
4 — Surgery Start Up
• “VERITAS Vision System Setup” on page 4-1
• “Front and Rear Panel Connections” on page 4-2
• “IV Pole Setup” on page 4-4
• “Handpiece Setup” on page 4-4
• “Startup” on page 4-10
• “Install the Tubing Pack” on page 4-12
• “Cup Fill” on page 4-13
• “Prime/Tune” on page 4-14
• “Verify Irrigation/Aspiration Balance” on page 4-17
• “Priming for Vitrectomy” on page 4-18
• “Selecting and Changing Mode Parameters” on page 4-19
• “System Check-out” on page 4-20
• “Pre-operative Sterilization” on page 4-22
• “End Case” on page 4-22
• “System Shutdown” on page 4-26
VERITAS Vision System Setup
This is a general overview of the steps to prepare the VERITAS
™
Vision System for surgery:
1. Attach the power cord to the power cord connector on the rear panel of the console (see
Figure 3-2 and Figure 4-2 ). Plug the power cord into a grounded power outlet.
NOTE: Do not position the equipment so that it is difficult to operate and disconnect the
device.
2. Attach the foot pedal to the foot pedal connector on the rear of the console (see Figure 3-2
and Figure 4-2 ).
3. Turn the system on by pressing the Power switch on the rear panel of the console (see
Figure 3-2 and Figure 4-2 ).
4. Press the On/Off button on the right side panel above the remote control storage
compartment (see Figure 3-1 ).
5. After completion of the self test, select the surgeon and program.
6. Install the tubing pack.