Janssen F Series, Руководство по эксплуатации

Страница: 68 / 315

66
8.5.3. Special tools for assembly
and maintenance
Normal machine operation:
No special tools are required for the
normal operation of the machine.
Maintenance and servicing:
Depending on the situation, you will
need various tools for maintenance
work:
1) Slotted screwdriver
10-12 mm blade width,
1.5 mm blade thickness
2) Open-ended spanner or socket
spanner
10 mm for M6
13 mm for M8
17 mm for M10
3) Allen
key (also Inbus®):
Allen size 3 for M4
Allen size 4 for M5
Allen size 5 for M6
Allen size 6 for M8
4) Hexalobular internal
key (Torx®)
T20 for M4 and M5 countersunk
screws
5) Hexalobular internal key with
internal pin (Torx®)
T40 for switch box door
6) Small electronics screwdriver for
electrical terminals
7) Phillips screwdriver
PZ 2 for electronic terminals on the
main switch
8) Plastic hammer
9) Pin punch
6 mm
10) Knife distance gauge*
11) Knife pin support*
*) The Janssen-specific special tools
can be requested from the manufac-
turer.
8.5 Special tools, equipment,
materials
The equipment and tools listed below
should be available before the
Janssen cookie formers are put into
operation for the first time.
8.5.1. Special materials
All materials of the Janssen cookie
formers are suitable for processing
food in accordance with their intended
use (
section "3.3 Basic operating
principle", p. 17
).
8.5.2. Special equipment
The gear unit and the bearings of the
machine must only be lubricated with
food-grade grease.