Isokern Magnum 86072-60, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 56

19
Assembly Instructions - 86072 - 60
The overall width dimension at the top of the smoke dome should
be approximately 53-1/2 to 54”. (Figure 35)
Note: The Magnum 86072 - 60 is designed to operate with two
flues. The top of the smoke dome allows for the placement of two
Isokern Modular Masonry DM chimneys or two solid fuel listed
metal chimneys of the appropriate size.
Step 21: Smoke dome top plate small, part # 77A, two required,
must field cut to fit.
Each of the two smoke dome top plate small, part # 77A,
will sit side by side on the smoke dome assembly, meeting at the
centerline of the smoke dome as a butt joint. The top plate, as
standard, comes with a recessed edge (or, a thickened center).
The recessed edge is approximately 3/8”and is intended to be the
bottom face of the top plate.
Each of the two top plate pieces must first be cut in width
in order to fit the overall smoke dome. Each top plate is to have
its width cut by 5”. (Figure 36). The cut edges must then become
the butt joint of the two top plates when set into place. (Figure 37)
Therefore, the width cuts for each top plate must be on opposite
edges of each piece.
The un-altered end of each top plate sits at the end of the
smoke dome assembly and rests on the smoke dome sloping side
wall.
At the recessed edge on the underside of the un-altered
ends of each of the two top plates, the thickened part of the top
plate will need to be ground down flush with the recessed edge
of the top plate so that the underside of the top plate does not ride
high on the smoke dome sloping sidewall.
Place the two top plate components on top of the second
tier smoke dome arrangement so that they meet at the centerline of
the smoke dome. (Figure 37)
The outlet hole sits closer to the back of the smoke dome.
The smoke dome top plates should sit flush with the front and back
of the smoke dome.
The top width dimension of the completed smoke dome
should measure approximately 53 1/2”- 54”. Each top plate has a
width cut dimension of approximately 27”. Two of the top plates
butted together should equal the smoke dome top width dimension
of approximately 54”.
The top plates may have some overhang at the ends of the
top plate assembly, which is acceptable.
Note: Be sure to put Earthcore Mortar on the contact surfaces of
the vertical joints where the components connect. Look for some
mortar to squeeze out along the joints of all contact surfaces as a
sign that the joint is thoroughly sealed with the approved mortar.
Fill any and all gaps in the assembly, as necessary, with the
approved mortar.
FIGURE 35
53½”
5”
FIGURE 36
FIGURE 37