Isokern Magnum 86072-60, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 56

Assembly Instructions - 86072-60
The Magnum 86072 - 60 is a custom unit made of standard
parts that are cut and fitted together in the field. The following
cut and assembly instructions identify the parts by name and by
part number, the quantity required, the field cut dimensions for
each modified component and the placement of each part in the
assembly.
Note:
At all component placement, be sure to mortar all contact
surfaces with Earthcore Mortar. Check for complete sealing of
each contact joint while assembly progresses
Step 1:
Base plate, part # 91, two required; All require field cutting.
Set the un-cut # 91 base plate components on an appropriate
masonry foundation. Cut one base plate to 30 1/2”. (Figure 13) Set
the two pieces so that the line of the grouping is a butt joint. (Figure
14). Set the cut # 91 pieces into place. This makes for square ends.
The overall length of the base plate assembly should measure 73-
1/2” and 28" deep.
Step 2:
Side wall, part # 90, eight pieces required, used “as is”. The
fire box side wall components are used without modification. The
side wall pieces stack four high on both the left and right hand ends
of the base plate arrangement (Figure 15)
The stack of four fire box side wall components will be
assembled in conjunction with the firebox back wall components
described in the following steps.
Step 3:
Back wall, part # 67, eight pieces required, to be “field
modified”. Cut the tongue off one end of each of the four # 67 back
wall components as shown. After cutting, four of these, cut pieces
should measure 38 1/2” from the cut end to the shoulder of the un-
altered end.(Figure 16)
The other four cut pieces should measure 22 1/4” from the
cut end to the shoulder of the unaltered end. (Figure 17)
Step 4:
Build the Magnum 86072 - 60 firebox by setting a 38 1/2”
# 67 back wall (from step 3) on the base plate with it’s tongue end
interlocked into the firebox side wall at the end of the baseplate.
The square cut end of this a 38-1/2” # 67 back wall
component sits flush with the back of the base plate with its cut end
past the centerline in the base plate arrangement (Figure 18).
Next set the 22-1/4” cut # 67 piece so that its tongue
end interlocks with the side wall component at the opposite end
of the base plate. The square cut end of the 22-1/4” # 67 should
make a snug butt joint with the square cut end of the 38-1/2” # 67
component (Figure 19).
15
FIGURE 13
DISCAR
D
DISCAR
D
43”
DISCAR
D
73
½
38 1/2“
22 1/4”
30 1/2”
30 1/2”
28”
FIGURE 14
FIGURE 15
FIGURE 16
FIGURE 17
FIGURE 18