Page 11
KEYPAD FUNCTIONS
The Elite LED Keypad consists of; an 18 button, backlit silicone rubber keypad, 14 LED indicators and an
internal piezo buzzer housed in a modern white plastic housing. The plastic housing has a hinged front lid to
cover and protect the rubber buttons when not in use. All the electronics are contained on a single circuit board
inside the housing.
Because the keypads communicate with the controller using data, the cable run from panel to keypads is secure
against tampering. For this reason there is no tamper switch on the keypad assembly. Access to the keypad
electronics will not disarm the panel.
BUTTONS
The 18 silicone rubber buttons are used for the following functions.
In normal operating mode the numeric keys are used for entering Access Codes. In Program Mode the numeric
keys are used for entering options & new values.
The buttons with text labels are used as function buttons and select the options indicated by the text and
normally precede other button presses, e.g. to enter Exclude Mode press <
EXCLUDE
> and the numeric key
corresponding to the zone number you wish to be excluded.
The
PROGRAM
Key is used to prefix option selections in the program modes e.g.<
PROGRAM
> 4 <
ENTER
>
selects User Code 4. The
PROGRAM
key is also used prior to a Master Code to enter user program mode from
normal operating mode.
The
ENTER
Key is used to enter access or program codes. It is normally used at the end of a button sequence.
The
CONTROL
button, if enabled at Address P170E Opt #7, is used to isolate day zone audible alarms if
temporarily not required and/or to directly control outputs if programmed at addresses P31-P38E Opt #6.
LED INDICATORS
The LED indicators are used to display system conditions including Zone status, Battery state, Tamper etc.
Please refer to the LED table on page 10 for a full explanation of the conditional displays.
INSTALLING RX-16 RADIO RECEIVER
The Elite 8D is fully high level compatible with the RX-16 radio receiver. The addition of this receiver will add
wireless capability to your system in the form or wireless PIR detectors, Wireless Radiokey transmitters and
wireless reed switch transmitters. The RX-16 receiver connects to the same communications port as the
keypads and can be installed , either inside the cabinet, or if preferred, may be installed at a remote location.
The RX-16 is available in 3 frequencies,303.875mhz ,433.92mhz or 27mhz.
The RX-16 receiver requires 4 cores and can successfully be run in 0.2mm unscreened cable over a distance of
up to 100metres. Like the keypads the RX-16 has 12v connections labeled
POS and NEG
which are wired to the
12v supply and CLK and DATA terminals for connection to the communications bus.
The green LED fitted to the RX-16 receiver will indicate when the unit is in "Learn" mode (Flashing - see P601E)
or when it is receiving an actual radio transmission (On Steady)
Содержание Elite Version 8D
Страница 56: ...Page 56 ...
