Idex Hale Sam, Техническое руководство

Страница: 92 / 223

72
If a valve fails to rotate in the correct direction, jams, or when the motor shaft is rotated in the
correct direction the valve ball rotates in the wrong direction; reference Akron Brass installation
instructions for Style 8600 Electric Actuator With Motor Driver (P/N 123248) and correct valves
sector gear location/orientation and then perform this procedure again.
4.6.
Removal And Replacement Of SAM MIVs
Refer to the MIV 2.0 OIM (FSG-MNL-00216), TM (FSG-MNL-00217), and/or PM
(FSG-MNL-00218) for MIV 2.0 information.
4.7.
Removal And Replacement Of SAM Sensors
SAM sensors, modules, and displays do NOT require additional ESD protect or ESD procedures.
All SAM sensors must be ordered thru Hale (or a FAST/OEM builder) to be plug and play, ready
for install in the SAM system. Do NOT substitute other sourced sensors into a SAM system.
4.7.1
Barometer (Atmospheric Pressure)
The barometric sensor (Figure 45) is secured to the top of the left intake (Q series) or right intake
(D series) with a mounted bracket using two (2) 1/4–20 X 1-1/4-in long washer head machine
screws (use Loctite 243 on threads).
Figure 45. Barometric Sensor
The sensor houses three pins, see Figure 45 for the pin layout and Table 26 for the pin connec-
tions. Notice the atmospheric port must remain open to the atmosphere.
Table 26. Barometric Sensor Wiring (From/To Listing)
From (Pin) To
A System Ground (Main Ground Stud – on pump body)
B Sensor Module / Connector B / Pin 10 (See Table 50)
C Sensor Module / Connector B / Pin 7 (See Table 50)
The sensor measures barometric pressure according to Table 74 (page 165).