Idex Hale Sam, Техническое руководство

Страница: 168 / 223

148
Figure 126. SAM Pump Controller I/O Testing (With Active Output)
Touch the red bubble to activate the desired output and it will turn from red to green to show that
the output signal is being sent. Touch again to turn off signal. Note that the output buttons are
not getting feedback from the corresponding SAM component so the device must be checked for
activation. On the input page the MIV–A is receiving feedback and the bubble will automatically
turn green when the device is activated.
4.15.3.1
Testing MIV Outputs
Touch the toggle Input/Output button on the screen to actuate the following outputs.
See Table 74 and Figure 127.
Table 74. MIV–A Output Testing
Button Name Function Special Comments
Pre Prime #3 RH Bot MIV PF Valve Air Pressure Required
AUX Output N/A
Air Prime Optional Air Primer
Pre Prime #1 LH MIV PF Valve Air Pressure Required
LED #1 LH Auto MIV Button Ring will turn green
LED #2 RH Auto MIV Button Ring will turn green
LED #3 RH BOT Auto MIV Button Ring will turn green
Prime Body Prime Body PF Valve Air Pressure Required
AB Drain AB Drain Manifold (bottom of
gearbox)
Air Pressure Required
Pre Prime #2 RH MIV PF Valve Air Pressure Required
Primer Start Primer Solenoid Primer will run (do not leave on
>45s)
Not Used N/A
If the desired function does not work verify power, harness connection, air pressure, and CAN
connection to the component. If all four items listed are good, replace the component under
test.