Idex Hale Sam, Техническое руководство

Страница: 67 / 223

47
As a general maintenance practice, tag (document/photograph/record) the pipe routing and lo-
cation (including the mating connector) for each drain line before disconnecting or removing it.
When replacing drain lines ensure service loops do NOT allow water to be trapped and cause
damage from freezing water.
4.3.4
Datalogger Guidelines
Hale provides datalogging capability for SAM. Contact Hale Customer Service (800 533.3569) if
a display or controller trouble exists. Utilize the following procedures only when instructed to do
so by Hale.
4.3.4.1
Export Datalogger From SAM Control Center
When directed by Hale Customer Service, download the data log file from the SAM Control Center
by performing the following.
A.
Open pump operator panel.
B. Gain access to USB dongle.
C. Connect a USB 2.0 flash drive to USB dongle. (See Figure 24, page 33; do NOT
connect the Hale USB Key for this purpose.)
D. Temporally, close panel.
E. On SAM Control Center, touch MANUAL MODE button. See Figure 1 (page 11).
F. Touch YES button. (See Figure 2, page 11.)
G. On SAM Control Center, touch and hold system options button until loading icon
completes circle (see Figure 25, page 34) and Enter Password screen is dis-
played (see Figure 26).
H. Using Enter Password screen, touch OEM/Technician passwords digits.
I. Touch ENTER button.
J. Touch BAM tab.
K. Touch Configuration Mode button.
L. Touch icon.
M. Temporally, open panel.
N. On rear of SAM Control Center, remove Hale USB Key.
O. Connect a USB 2.0 flash drive to USB dongle. (See Figure 24, page 33; do NOT
use the Hale USB Key for this purpose.)
P. Touch Export Data Log To USB button.
Q. Wait for Export Complete to display.
R. If Export Failed displays, repeat entire procedure using a different USB 2.0 flash
drive.
S. When Export Complete displays, on rear of SAM Control Center, remove USB flash
drive.
T. On MENU screen, touch Reboot to GUI.
U. Close pump operator panel.