58
Table 14 provides the SAM system from/to wire listing.
Table 14. Twister Wiring (From/To Listing)
From Twister
(Pin)
To SAM
Breaker Box
To Control Center
Black Connector
1
(Power)
[Input] Connector 1, Pin 3
N/C
2
(Ground)
[Input] Main Ground Stud (On Pump Body)
3
Interlock
[Input] N/C
4
(CAN High)
[Bus]
19
(CAN2 High)
5
(CAN Low)
[Bus]
18
(CAN2 Low)
6
(CAN Shield)
[Bus]
N/C
Refer to Table 15 for a list of tools and/or consumables required for this procedure.
Table 15. Twister Tools And Consumables List
Standard Tools
Special Tools
Consumables
PPE (Eye and Hand Protection)
None
Cable Ties (As Required)
11/32-in Nut Driver (Or Wrench
Or Socket With Ratchet)
Twister
<See FSG-PL-01505, Sheet 1>
#1 Phillips Screwdriver
Wire Cutter
If the Twister fails to control engine speed (or activate an idle) or is damaged; replace the Twister
as follows.
Removal
A.
Open SAM panel.
B.
Note cable tie locations, cut ONLY ties required to R&R Twister.
C.
Tag and disconnect electrical connector.
D.
Using screwdriver and nut driver (or wrench/socket), loosen four [4] machine
screws (with washers) and locking nuts.
E.
Remove three [3] screws (with washers) and locking nuts.
F.
Support Twister while removing remaining screw (with washer) and locking nut.
G.
Remove Twister.
Installation
A.
Align Twister with panel opening and support Twister during installation.
B.
Hand start four [4] screws (with washers) and locking nuts.
C.
Using screwdriver and nut driver (or wrench/socket), tighten four [4] screws (with
washers) and locking nuts.
D.
Connect electrical connector according to tags.
E.
Install cable ties cut to R&R Twister as noted.
F.
Close SAM panel.
Содержание Hale Sam
