Idex Hale Sam, Техническое руководство

Страница: 131 / 223

111
Refer to Table 63 for a list of tools and/or consumables required for this procedure.
Table 63. Auxiliary Cooling Solenoid Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
Wire Cutter Cable Ties (As Required)
9-16-in Wrench Auxiliary Cooling Solenoid
< See FSG-PL-01501, -01502, -01503,
Sheet 8>
13/16-in Wrench Loctite 580 (Or Equivalent)
If the solenoid fails or is damaged; replace the solenoid as follows.
Removal
A.
Note cable tie locations, cut ONLY ties required to R&R solenoid.
B. Tag and disconnect cooling water tube (3/8-in tubing) as follows.
Push collar to release tubing.
Pull tubing out of elbow.
C. At solenoid, tag and disconnect electric connector.
D. Note solenoid port markings (A and P).
E. Using 9/16-in wrench, hold nipple (below solenoid) from turning. See Figure 81.
Figure 80. Auxiliary Cooling Solenoid And Fittings
F. Using 13/16-in wrench, remove solenoid (with elbow).
G. Using 9/16-in wrench, remove elbow. (Use vise or 13/16-in wrench to hold sole-
noid.)
Installation
A.
Apply Loctite 580 to threads of existing/new elbow.
(Use sealant sparingly to prevent check valve damage.)
B. Install elbow according to noted port marking.