Idex Hale Sam, Техническое руководство

Страница: 76 / 223

56
D. Align and push buzzer thru panel.
E. Install ring. (Use slip joint plyers to tighten nut.)
F. Connect two [2] wires according to tags.
G. Install cable ties cut to R&R buzzer as noted.
4.4.4 Emergency Idle Switch
An emergency idle switch (Figure 37) is collocated with each auxiliary SAM Control Center. The
switch is a single pole normally open momentary switch. A switch shroud is provided to prevent
inadvertent activation.
Figure 37. Emergency Idle Switch Panel
If an auxiliary SAM Control Center is added to the SAM system, the switch may be mounted via a
thru hole drilled (or punched) in the panel adjacent to the auxiliary SAM Control Center. Refer to
FSG-PL-01505, sheet 4, for details. Table 12 provides the SAM system from/to wire listing.
Table 12. Emergency Idle Switch Wiring (From/To Listing)
From Emergency
Idle Button (Pin)
To SAM
Breaker Box
To SAM Control Center
Connector A (Black)
1 Connector 1, Pin 3 N/C
2 N/C 1 (Engine Idle) [Input]
NOTE: Pins are NOT marked on the switch, connect as desired.
Refer to Table 13 for a list of tools and/or consumables required for this procedure.
Table 13. Emergency Idle Switch Tools And Consumables List
Standard Tools Special Tools Consumables
PPE (Eye and Hand Protection) None Cable Ties (As Required)
Slip Joint Plyers
(At Least 25 mm Jaw Opening)
Switch
<See FSG-PL-01505, Sheet 4>
7/8-in Wrench
Screwdriver (Flat or Phillips)
Wire Cutter
If the switch fails to activate an idle or is damaged; replace the switch as follows.
Removal
A.
Open SAM panel.
B. Note cable tie locations, cut ONLY ties required to R&R emergency idle switch.