Chapter 3. Installation
47
Configuring the modem for a destination country
Different countries have different requirements for how modems must function.
Therefore, you must configure the modem to match the communication defaults of the
country it will be used.
Using the global wizard utility
1. Insert the MT5634ZBA System CD into the CD-ROM drive. The Autorun dialog box
appears.
2. Click Initial Setup and Country Selection. The Global Wizard dialog box appears.
Click Next.
3. View the Global Wizard as it searches for the modem and identifies it. Click Next.
4. Select the country in which the modem will be used, and then click Next.
5. Review the choice of country. If it is correct, click Next to configure the modem.
6. When the Global Wizard message states the parameters have been set, click Finish
to exit.
MultiTech Systems MultiModem MT5600BA modem (North American/
International usage)
Use the following procedures to install the MultiTech Systems MultiModem MT5600BA
external modem, modem driver, and global wizard utility.
Installing the MultiTech MT5600BA modem
1. Unpack the contents of the modem packing box.
2. Verify that the workstation is turned Off during this modem installation.
3. Using a DB-25 to DE-9 RS-232 serial cable, plug the DB-25 connector end into the
modem.
4. Plug the DE-9 connector end of the cable into Serial Port A (COM 1) of the
workstation.
5. Insert the barrel-shaped power plug into the power jack on the modem. Plug the
power module into a standard AC power wall outlet.
6. Connect the customer’s supplied phone line to the line port of the external modem.
7. Using the external modem’s supplied phone cord, connect a line between the
external modem’s phone port and the workstation’s internal modem line port (see
Figure 29.).
8. Turn on the external modem (the power switch is located on the front of the case),
and the workstation. Proceed with installing the modem driver.
Installing the modem driver
1. Upon startup of the workstation, Windows should detect the new modem and open
the Install New Modem wizard.
2. In the Install New Modem wizard, select Don’t detect my modem; I will select it
from a list, and then click Next. A dialog box with a list of manufacturers and a list of
modem models is displayed.
3. Insert the system CD into the CD-ROM drive, and then click Have Disk.
Содержание TotalStorage SAN256N Director 2045-N16
