IBM TotalStorage SAN256N Director 2045-N16, Руководство по установке и обслуживанию, Страница: 104 / 157

SAN256N Director 2045-N16
84
9. After about 90 seconds you will see the following message:
The changes were applied successfully
[OK]
10. This will take you back to the General tab display.
11. Click OK to return to the Navigation Tree Menu.
12. Verify that the applicable board has been taken offline in the Boards display.
13. You should also check that the Online LED on the TFIO board is not lit. A final place
you can check the status is on the 8 character display on the TCM Module. You
should see the following:
[OFLN]IOnn (nn is the IO slot number)
14. Remove all connected data cables from ports on the TFIO card and label each
cable as they are removed.
15. Install dust covers in TFIO board port connectors where fiber optic cables have
been removed.
16. Loosen the spring-loaded captive screws from the top and bottom TFIO card ejector
latches. Grasp both card ejector latches and pull the latch tabs forward to unlatch
the board.
17. Using the card ejector latches, pull and slide the board out from the SAN256N
director chassis slot guides.
18. Place the removed TFIO in a plastic antistatic bag.
Installing a TFIO blade
1. Remove the new TFIO blade from the plastic antistatic bag.
2. Refer to the front and rear chassis views as a reference on where the TFIO blades
are located on the SAN256N director.
3. Carefully push and slide the module into the SAN256N chassis until firmly seated
against backplane connector.
4. Push and lock card ejector tabs closed to secure the TFIO blade into position in
SAN256N chassis. Secure the board by tightening the spring loaded screws in the
top and bottom card ejector latches.
5. On the Enterprise Manager Client select the Boards tab then right click the
previously inserted board. Select Versions from the drop down menu.
6. Scroll over to the Valid column on the far right to confirm that the code is valid.
Note: If the Flash version and Firmware Version do not match, perform a code load
from the Code Load button on the toolbar.
7. To Online the board right click the appropriate board then select Configuration from
the drop down menu.
Attention:
A TFIO blank panel air baffle must be installed in any TFIO
chassis slot if the removed board is not being replaced, otherwise damage to
equipment may result.