IBM TotalStorage SAN256N Director 2045-N16, Руководство по установке и обслуживанию

Страница: 105 / 157

Chapter 5. Hardware maintenance procedures
85
8. Select the Online radio button then click OK.
You will see the following message:
Do you want to set the Admin mode?
9. Select Yes.
Admin mode change may take about one minute.
Are you sure you want to continue.
10. Select Yes.
Changes were applied successfully.
11. Click OK. You will be returned to the Boards tab and the Navigation Tree menu.
12. Check the Heartbeat LED blinking pattern to verify that blinking pattern is normal
(normal is on/off once per second).
13. Re-install the cables back into their appropriate ports to return to the system to its
original configuration.
TSW module replacement procedures
Use the following procedures to do a hot swap replacement of a TSW board. Figure 37
on page 85 provides a visual reference.
Figure 37. TSW Module; replacing
Attention: Refer to safety notices before starting an installation.
Attention: Use a properly attached ESD wrist strap when handling any
TFIO, TSW, or TCM module, otherwise damage to equipment may result.
TSW Module
Ejector / Latch
Ejector / Latch
Latch Closed
Latch Screw
Latch Closed
Latch Screw