IBM BladeCenter HS22V 7871, Руководство по диагностике и обслуживанию

Страница: 96 / 258

4. Orient the expansion card and slide the slots at the back end of the card onto
the pins on the expansion-card standoff; then, gently pivot the card into the
blade server expansion connector.
5.
Firmly press on the indicated locations to seat the expansion card.
Note: For device-driver and configuration information to complete the
installation of the expansion card, see the documentation that comes with the
expansion card.
6. Install the cover onto the blade server (see “Closing the blade server cover” on
page 56).
7. Install the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 53).
Installing a storage interface card
Use this information to install a storage interface card in the blade server.
The storage interface card controls the SAS storage drives. The following
illustrations and installation instructions show how to install a ServeRAID-MR10ie
controller into the CIOv expansion connector of the blade server. The illustrations
and installation instructions are similar for other CIOv storage interface cards.
Note: The backup-battery will be installed in DIMM connector ten and might
affect how much memory is recognized by the blade server. Review the tables in
“Installing a memory module” on page 64 to make sure that your memory
configuration will not be affected.
ServeRAID
controller
Cable "B "
Attention: Before you install a ServeRAID-MR10ie controller in the blade server,
make sure the PCIe speed is set to Gen1. You can configure the PCIe speed in the
Setup utility by selecting
System Settings
and
Devices and I/O Ports
.
To install a storage interface card, complete the following steps.
1. Locate the CIOv expansion connector (see “Blade server connectors” on page
14).
80
BladeCenter HS22V Type 7871 and 1949: Problem Determination and Service Guide