IBM BladeCenter HS22V 7871, Руководство по диагностике и обслуживанию

Страница: 89 / 258

1. The following illustration shows how to install the battery in the system board.
2.
The illustrations in this document might differ slightly from your hardware.
To install the battery, complete the following steps:
1. Before you begin, read “Safety” on page v and “Installation guidelines” on
page 49.
2. If the blade server is installed in a BladeCenter unit, remove it (see
“Removing the blade server from the BladeCenter unit” on page 52 for
instructions).
3. Remove the blade server cover (see “Removing the blade server cover” on
page 55 for instructions).
4. If an optional expansion unit is installed, remove the expansion unit (see
“Removing an optional expansion unit” on page 57 for instructions).
5.
Follow any special handling and installation instructions that come with the
battery.
6. Locate the battery connector on the system board (see “Blade server
connectors” on page 14).
7. Orient the battery so that the positive (+) side faces in towards the center of
the blade server.
8. Tilt the battery so that you can insert it into the bottom of the socket.
9. As you slide the battery into place, press the top of the battery into the socket.
10. If you removed a rubber cover from the battery holder, use your fingers to
install the battery cover on top of the battery connector.
11. Install the optional expansion unit, if you removed one from the blade server
to replace the battery (see “Installing an optional expansion unit” on page 58
for instructions).
12.
Install the cover onto the blade server (see “Closing the blade server cover”
on page 56).
13. Install the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 53).
14. Turn on the blade server, start the Setup utility, and reset the configuration
(see “Using the Setup utility” on page 20 for instructions).
Chapter 5. Removing and replacing blade server components
73