IBM BladeCenter HS22V 7871, Руководство по диагностике и обслуживанию

Страница: 74 / 258

Installing an optional expansion unit
Use these instructions to install an optional expansion unit.
The optional expansion units supported for this blade server are the PCI Express
I/O expansion unit.
Attention: If a horizontal combination-form-factor (CFFh) expansion card is
installed on the blade server system board, you cannot install an optional
expansion unit.
Notes:
1. The following illustration shows an optional expansion unit in a blade server.
2.
The illustrations in this document might differ slightly from your hardware.
To install an optional expansion unit, complete the following steps.
Blade server
cover release
Expansion unit
Blade server
cover release
1. Locate the blade expansion connector and remove the cover if one is installed
(see “Blade server connectors” on page 14).
2. Touch the static-protective package that contains the optional expansion unit to
any
unpainted metal surface on the BladeCenter unit or any unpainted metal
surface on any other grounded rack component; then, remove the optional
expansion unit from the package.
3. Orient the optional expansion unit as shown in the illustration.
4.
Lower the expansion unit so that the slots at the rear slide down onto the cover
pins at the rear of the blade server; then, pivot the expansion unit down onto
the blade server.
5. If the expansion unit has an extraction device (such as a thumbscrew or a
lever), use it to fully engage the expansion unit on the blade server; otherwise,
press the expansion unit firmly into the closed position until it clicks into place.
6. Install the cover onto the blade server (see “Closing the blade server cover” on
page 56).
7.
Install the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 53).
58
BladeCenter HS22V Type 7871 and 1949: Problem Determination and Service Guide