IBM BladeCenter HS22V 7871, Руководство по диагностике и обслуживанию

Страница: 100 / 258

1.
Identify the location on the blade server where the SSD drive tray will be
installed (see “Blade server connectors” on page 14).
2. Touch the static-protective package that contains the drive tray to any
unpainted metal surface on the BladeCenter unit or any unpainted metal surface
on any other grounded rack component; then, remove the hard disk drive
from the package.
3. Orient the SSD drive tray so that the release latches are towards the front of
the blade server.
4.
Align the screw holes in the drive tray with the screw holes on the blade
server.
5. Use a screwdriver to install two screws into the SSD drive tray and tighten
the screws until the SSD drive tray is secure.
Note: Make sure the SSD drives are installed into the same SSD connector
that they were removed from to maintain any RAID array that might be
configured.
6. Install any SSD storage drives that were removed from your blade server (see
“Installing a SSD storage drive” on page 62).
7. Install the front bezel onto the blade server (see “Installing the bezel
assembly” on page 60).
8. If an expansion was installed, install the expansion unit (see “Installing an
optional expansion unit” on page 58).
9.
Install the cover onto the blade server (see “Closing the blade server cover”
on page 56).
10. Install the blade server into the BladeCenter unit (see “Installing the blade
server in a BladeCenter unit” on page 53).
84
BladeCenter HS22V Type 7871 and 1949: Problem Determination and Service Guide