IBM 2109 - SAN Fibre Channel Switch Model S16, Руководство по обслуживанию

Страница: 40 / 178

2. Slide the switch back and forth on the rack several times to ensure that it
moves freely. Move the switch partially forward and tighten the mounting screws
on the rear brackets that were left finger tight.
Step 4. Locking the switch in the rack using the mounting ears
installed in step 1
1. Slide the switch fully back in the rack.
2. Using the remaining screws provided with the locking ears, lock the switch in
the rack.
This completes the rack mounting of the switch.
To install GBICs, see “Installing GBICs” on page 25. To install the optional power
supply, see “Installing the optional power supply”.
Installing the optional power supply
Before installing the optional power supply, read the following danger notices.
DANGER
To prevent a possible electrical shock during an electrical storm, do not
connect or disconnect cables or station protectors for communications
lines, display stations, printers, or telephones. (72XXD003)
DANGER
Do not attempt to open the covers of the power supply. Power supplies are
not serviceable and are replaced as a unit. (72XXD300)
DANGER
An electrical outlet that is not correctly wired could place hazardous
voltage on metal parts of the system or the products that attach to the
system. It is the customer’s responsibility to ensure that the outlet is
correctly wired and grounded to prevent an electrical shock. (72XXD201)
SJ000049
Figure 10. Inserting slides into the rack rails
24
IBM SAN Fibre Channel Switch: 2109 Model S16 Installation and Service Guide