IBM 2109 - SAN Fibre Channel Switch Model S16, Руководство по обслуживанию

Страница: 122 / 178

Related error messages: DIAG-INIT, DIAG-PORTDIED, DIAG-XMIT,
DIAG-TIMEOUT, DIAG-ERRSTAT, DIAG-STATS, DIAG-PORTWRONG, DIAG-DATA,
DIAG-PORTABSENT.
diagClearError
Figure 51 shows the diagClearError command, which clears diagnostic errors that
are detected on a specified port. The command syntax is
diagClearError <port#>
.
Without the port# parameter, all errors are cleared.
Note: Issuing this command does not clear the error log.
diagDisablePost
Figure 52 on page 107 shows the diagDisablePost command, which disables
POST processing. The startup time without POST processing is approximately 50 -
55 seconds (based on a 2109 Model S16) for warm or cold startups. A switch that
is restarted without POST generates the DIAG-POST_SKIPPED error.
Note: IBM recommends that POST processing always be run to ensure the
operational status of the switch during the power-on stage.
switch:admin> crossPort Test
Running Cross Port Test ............
switchName:
JR-6011
switchType: 3.1
switchState: Testing
switchRole: Disabled
switchDomain: 1 (unconfirmed)
switchId: fffc01
switchWwn: 10:00:00:60:69:00:60:11
port 0: sw Testing Loopback->1
port 1: sw Testing Loopback->0
port 2: sw Testing Loopback->7
port 3: sw Testing Loopback->6
port 4: sw Testing Loopback->5
port 5: sw Testing Loopback->4
port 6: sw Testing Loopback->3
port 7: sw Testing Loopback->2
Port SNMP Physical Flags
___________________________
0: Testing In_Sync PRESENT ACTIVE E_PORT G_PORT U_PORT SEGMENTED CBL_LB LOGIN
1: Testing In_Sync PRESENT ACTIVE E_PORT G_PORT U_PORT SEGMENTED CBL_LB LOGIN
2: Testing In_Sync PRESENT ACTIVE E_PORT G_PORT U_PORT SEGMENTED CBL_LB LOGIN
3: Testing In_Sync PRESENT ACTIVE E_PORT G_PORT U_PORT SEGMENTED CBL_LB LOGIN
4: Testing In_Sync PRESENT ACTIVE E_PORT G_PORT U_PORT SEGMENTED CBL_LB LOGIN
5: Testing In_Sync PRESENT ACTIVE E_PORT G_PORT U_PORT SEGMENTED CBL_LB LOGIN
6: Testing In_Sync PRESENT ACTIVE E_PORT G_PORT U_PORT SEGMENTED CBL_LB LOGIN
7: Testing In_Sync PRESENT ACTIVE E_PORT G_PORT U_PORT SEGMENTED CBL_LB LOGIN
8: Testing UNKNOWN PRESENT ACTIVE G_PORT
Figure 50. crossPortTest command example
switch:admin> diagClearError
Figure 51. diagClearError command example
106
IBM SAN Fibre Channel Switch: 2109 Model S16 Installation and Service Guide