IBM 2109 - SAN Fibre Channel Switch Model S16, Руководство по обслуживанию

Страница: 133 / 178

Appendix C. Error messages
This appendix explains the error message format and possible errors, including:
v
“System error message formats”
v
“Diagnostic error message formats” on page 118
v
“Error message numbers” on page 119
v
“Repair action code meanings for diagnostic error messages” on page 121
v
“Diagnostic error messages” on page 122
v
“System error messages” on page 125
System error message formats
There is only one error message format for the switch whether you are gathering
information from the local RS-232 serial port or using a remote Telnet session.
Errors are listed in reverse chronological order. Up to 64 messages can be held in
the buffer. If the 64 message limit is exceeded, the oldest message is deleted to
make room for the newest message.
The errShow command displays all detected errors. The output provides additional
information over the front panel display. The following information is displayed by
the errShow command:
v
Task ID
v
Task name
v
Date and time of the error
v
Number of occurrences
v
Error type
v
Error level
v
A description of the error
v
The error number is displayed for diagnostic errors
Note: The error counter goes to a maximum of 999.
The display halts after each error is displayed, prompting you to either press Enter
to continue or type a
Q
to quit. Continue pressing Enter until the prompt (=>) is
displayed. In Figure 62 on page 118, Error 02 represents a system error and Error
01 represents a diagnostic error (error number #004). Only diagnostic errors are
assigned error numbers.
© Copyright IBM Corp. 1999, 2000
117
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|