IBM 2109 - SAN Fibre Channel Switch Model S16, Руководство по обслуживанию

Страница: 128 / 178

Note: When running the spinSilk test, you must set the operating mode value to 0
or 1. Modes 2 and 3 do not send out the extended link parameters (ELP)
used to discover switches. If the ELP is not sent, the switch does not know
that the port is connected to another port on the same switch, and the test
fails. Use operating mode 0 when running the spinSilk test.
The command syntax is
spinSilk nMillions
, where:
nMillions
is the number of frames for the test to execute expressed in millions of
frames.
If you do not include the nMillions parameter, the spinSilk test runs until you press
Enter.
Table 36. spinSilk command example 1
switch:admin> spinSilk 2
RunningSpin Silk .............
One moment please
switchName:
SR-7371
switchType: 2.2
switchState: Testing
switchRole: Disabled
switchDomain: 1 (unconfirmed)
switchId: fffc01
switchWwn: 10 : 00 : 00 : 60 : 69 : 00 : 73 : 71
port
port
port
port
port
port
port
port
port
port
port
port
port
port
port
port 0:
1:
2:
3:
4:
5:
6:
7:
8:
9:
10:
11:
12:
13:
14:
15: cu
sw
sw
lw
lw
sw
sw
sw
sw
sw
sw
sw
sw
sw
sw
cu Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing
Testing Loopback->15
Loopback->11
Loopback->7
Loopback->4
Loopback->3
Loopback->9
Loopback->14
Loopback->2
Loopback->13
Loopback->5
Loopback->12
Loopback->1
Loopback->10
Loopback->8
Loopback->6
Loopback->0
Transmitting ... done.
Spinning ...
112
IBM SAN Fibre Channel Switch: 2109 Model S16 Installation and Service Guide