IBM 2109 - SAN Fibre Channel Switch Model S16, Руководство по обслуживанию

Страница: 138 / 178

Table 40. Action codes and recommended actions (continued)
Action
code Recommended action
4 Replace the power supply. See “Replacing the power supply” on page 45.
Diagnostic error messages
This section provides information on the probable cause of a diagnostic error and
what actions to take.
Table 41. Diagnostic error messages
Message Failing test Description Probable cause Action
DIAG-BADINT
Err#1030
Err#2030 centralMemoryTest
cmiTest The port received an interrupt
when not expecting one. ASIC failure 1
DIAG-
BUS_TIMEOUT
Err#0B0F
Err#4040F portRegTest
sramRetentionTest The ASIC register or ASIC SRAM
did not respond to an ASIC data
access. ASIC failure 1
DIAG-CAMINIT
Err#223B CamTest The port failed to initialize due to
one of the following reasons:
v
Switch is not disabled
v
Diagnostic queue absent
v
Malloc failed
v
Chip is not present
v
Port is not in loopback mode
v
Port is not active
Software operational
setup error or main
boad failure Retry,
restart or
replace the
mainboard
assembly
DIAG-CAMSID
Err#223C camTest The ASIC failed SID NO
translation test. ASIC failure 1
DIAG-CLEAR_ERR
Err#0001 The port’s diag error flag (OK or
BAD) is cleared. Informational only None
required
DIAG-CMBISRF
Err#1021 centralMemoryTest The central memory SRAMs of
the ASIC did not complete the
BISR within the timeout period. ASIC failure 1
DIAG-CMBISRTO
Err#1020 centralMemoryTest The central memory SRAMs of
the ASIC did not complete the
BISR within the timeout period. ASIC failure 1
DIAG-CMERRPTN
Err#102B centralMemoryTest An error was detected at the
wrong port. ASIC failure
DIAG-CMERRTYPE
Err#102A centralMemoryTest The port got the wrong CMEM
error type. ASIC failure 1
DIAG-CMICKSUM
Err#2036 cmiTest The CMI message received failed
the bad checksum test. ASIC or system board
failure 1
DIAG-CMIDATA
Err#2035 cmiTest The CMI data received did not
match the data transmitted. ASIC or system board
failure 1
DIAG-CMIINVCAP
Err#2034 cmiTest An unintended ASIC erroneously
got CMI capture flag. ASIC or system board
failure 1
DIAG-CMINOCAP
Err#2033 cmiTest The CMI intended receiver ASIC
failed to get the CMI capture flag. ASIC or system board
failure 1
122
IBM SAN Fibre Channel Switch: 2109 Model S16 Installation and Service Guide
|
|
| |
||
|
|
|
|
|
||
|||||
|
|
| |
| |
| ||
|
|
|
| |
| |
|
| ||
|
| ||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| ||
| ||
|
| ||
| ||
|
|
| ||
|
| ||
|
| ||
|
| ||
|
| ||
| ||
|
| ||
| ||
|
| ||
| |
| |
|
| ||
| |
| |
|
| ||
| |
| |
|
| ||
| |
| |