IBM 2109 - SAN Fibre Channel Switch Model S16, Руководство по обслуживанию

Страница: 36 / 178

Table 14. Pre-installation checklist (continued)
Step Customer action or decision Comments and references
6 Decide on the switch network
parameters.
Ethernet port configuration decisions:
v
Static IP address _____________
v
Netmask (if required)__________
If the switch, the SNMP manager, or
the Syslog server are on different
TCP/IP subnets (see note), assign the
default network gateway address and
route table entries.
Attention: Save this configuration
for future reference.
Obtain the switch network parameters
from your network administrator.
Attention: Use of incorrect network
parameters can cause problems on the
Ethernet network.
7 Install the Ethernet cable from the
server (see note) to the network hub. None
8 Install the Ethernet cable from the
network hub where the switch will be
installed. None
Note: The term server used here refers to the computer used for the IBM StorWatch
Specialist.
Installing the switch
The 2109 Model S16 Switch is installed either in a rack-mount configuration or a
tabletop configuration.
Note: Before installing GBICs, power cords, and the optional second power supply,
install either the rubber tabletop mounting feet or install the switch in the
rack.
Tabletop installation
The switch is shipped in its tabletop configuration. Adhesive rubber feet are
supplied. These must be applied to the bottom of the switch in the four depressions
provided.
1. Turn the switch upside down and lay it on its top.
2. Clean the four depressions by wiping them free of dust.
3. Remove the rubber feet from the sheet that is provided with the shipping kit,
and place one rubber foot in each depression.
4. Firmly press the rubber feet in place.
5. Return the switch to its normal upright position, and place it in its intended
service location.
6. Go to “Installing the optional power supply” on page 24 (even if you do not have
an optional power supply).
Rack-mount installation
Read the following statements before starting the rack-mount installation:
20
IBM SAN Fibre Channel Switch: 2109 Model S16 Installation and Service Guide
|
|
|
|
|
|
|