HydraMaster Steamatic 8800 TMU, Руководство пользователя

Страница: 6 / 148

Steamatic 8800 TMU Owner’s Manual - iv
Steamatic 8800 TMU
list of figures
figure 1-1. Hard Water Map of Mainland United States ..................................... 1-17
figure 2-1. location of Roof Vents in Vehicle ...................................................... 2-1
figure 2-2. Recommended location of Steamatic 8800 TMU in Van ................... 2-3
figure 2-3. Install fuel Pump, outlet Side Up....................................................... 2-6
figure 2-4. fuel Pump Must be in Vertical Position .............................................. 2-6
figure 4-1. Steamatic 8800 TMU Upper Dash Assembly ..................................... 4-1
figure 4-2. Steamatic 8800 TMU lower Dash Assembly ..................................... 4-2
figure 4-3. Heat Selector Valve ............................................................................ 4-3
figure 4-4. Thermostat Dial .................................................................................. 4-3
figure 4-5. Throttle Switch .................................................................................... 4-3
figure 4-6. location of Water Pressure Selector Valve ....................................... 4-4
figure 4-7. location of Chemical System Switches .............................................. 4-5
figure 5-1. Remove Valve Cap and Valve Assembly ............................................ 5-9
figure 5-2. Inspect Manifold and old Valves ........................................................ 5-9
figure 5-3. Replace Center Inlet Check Valve
with Modified Check Valve
.............................................................. 5-10
figure 5-4. Apply Grease and Install Valves ....................................................... 5-10
figure 5-5. Replace Valve Cap and Torque to 95 ft. lbs. (13 m kgs) ................... 5-10
figure 5-6. Separate Manifold from Crankcase .................................................. 5-11
figure 5-7. Seal Assemblies May Come off with Manifold ................................. 5-11
figure 5-8. examine Ceramic Plungers .............................................................. 5-11
figure 5-9. Remove Stainless Steel Plunger bolt and Ceramic Plunger ............ 5-12
figure 5-10. Install o-ring, Apply Sealant and Slide Plunger
over Plunger Guide ......................................................................... 5-12
figure 5-11. extract Retainers and Seals ........................................................... 5-13
figure 5-12. Seal Kit and Insertion Tool for Seal Installation .............................. 5-14
figure 5-13. Install Seal Assembly Using o-Ring Grease .................................. 5-14
figure 5-14. Install Retainers into Cavities ......................................................... 5-15
figure 5-15. Press low Pressure Seal Assembly into Cavity ............................. 5-15
figure 5-16. Re-install Manifold and Torque fasteners ...................................... 5-16
figure 5-17. Torque Sequence in “X” Pattern ..................................................... 5-16
figure 5-18. Torque bolts to 22 ft. lbs (3 m kgs) ................................................. 5-16
figure 5-19. Recirculation fitting ........................................................................ 5-18