HydraMaster Steamatic 8800 TMU, Руководство пользователя

Страница: 39 / 148

4-3 - Operating Instructions
Steamatic 8800 TMU
SettIng tHe temperature
Depending upon the type of cleaning jobs you need to do, there will be times where
you will not need the maximum heat and vacuum
available. There are a few different ways you can
optimize the Steamatic 8800 TMU to the size of the
job.
The different scenarios can be defined as follows:
Maximum 1. – Dual wands or rotary machine
usage. This means that all available power is
required.
Set the Heat Selector valve to “HoT” - a.
see .
Rotate the thermostat dial to “260” - see
b.
figure 4-4.
Increase engine rpm to “HIGH” - see
c.
figure 4-5.
High Heat/Reduced Vacuum 2. – Dual wand with
short hose runs or single wand at longer hose
runs to the job site.
Set the Heat Selector valve to “HoT”. a.
Rotate the thermostat dial to “260”. b.
Increase engine rpm to “MID”. c.
Reduced Heat/full Vacuum 3. – Single wand with
short hose runs to the job site.
Set the Heat Selector valve to “WARM”. a.
Rotate the thermostat dial to desired b.
temperature.
Increase engine rpm to “HIGH”.
c.
low Heat/Reduced Vacuum 4. – Upholstery or any
reduced solution flow cleaning.
Set the Heat Selector valve to “WARM”. a.
Rotate the thermostat dial to desired b.
temperature.
Increase engine rpm to “MID”.
c.
Never perform cleaning operations when the
truckmount engine is running at the IDle throttle position. To do so will increase
the risk of serious component or engine damage.
figure 4-3. Heat Selector Valve
figure 4-4. thermostat dial
figure 4-5. throttle
Switch