Husqvarna Viking Platinum MN 1000, Руководство пользователя

Страница: 19 / 56

PREPARATIONS – 19
THREADING THE THREAD RACK
• Place a thread spool on the spool pin at the rear right.
Pull out some thread.
• Pass the thread through the bottom eyelet of the rear
metal rack (1).
• Proceed to pull the thread through the vertical eyelet (2).
• Pass the thread through the corresponding eyelet of
the front metal rack (3).
• Feed the thread through the eyelet of the upper tension
knob (4).
Pass the thread (from right to left) in between the
tension plates (5).
• Hold the upper end of the thread guide tube (6), and
carfully remove it, by pulling it upwards and then out.
Repeat with the other end of the tube.
• Take the threading tool, and insert it completely into
the thread guide tube. Hook the thread around the
threading tool (7).
• Carefully pull the threading tool (and thread)back
through the tube (7).
Unhook the thread.
Snap the plastic tube ends back into place.
Pull the thread out of the tube (enough thread to be
able to continue threading down the entire thread path
down to the presser foot).
THREADING THE TOP OF THE MACHINE
• Guide the thread from right to left under the upper
thread tension clip (8).
On the machine cover, there are arrows guiding you through the correct
threading path.
• Thread around the thread guide as indicated by the
arrows.
• Turn the thread 1,5 turns around the lower thread
tension knob (9).
• Thread around the thread guide as indicated by the
arrows.
• Guide the thread from left to right under the lower
thread tension clip (10).
Note: For spool 1-5, thread from right to left, For spool 6-10,
thread from left-right.
THREADING THE NEEDLE BAR FRAME
• Pass the thread over the upper thread course (11).
• Pass the thread down through the right path of the
threading slot (12). Pull the thread around the bottom
of the divider and bring the thread up again.
• Pass the thread through the eye of the take-up lever
from right to left (13), and then down through the slot
again.
THREADING THE NEEDLE
• Lead the thread through the eylet in the needle bar (14).
• Pass the thread behind the thread hook from right to
left (15).
• Thread the needle from front to back and then through
the hole in the presser foot (16).
• Pull the thread up and around the thread cutter (17),
from the left to the right.