Hughes HX90, Руководство по установке, Страница: 16 / 124

Chapter 2 • Preparing for installation
16
1039456-0001 Revision A
Before proceeding, make sure you have the correct power supply. Check the part
number on the power supply and refer to Figure 3.
•
Always use the power supply provided with the satellite router. The router’s
performance may suffer if the wrong power supply is used.
•
Connect the AC/DC power supply to a three-wire, grounded outlet with an
input of 110/240 VAC. A suitable surge protector is recommended to protect
the satellite router from possible damage due to power surges.
•
Always connect the DC power cord to the HX90 rear panel before applying
power to the power supply. If you apply power to the power supply and
then connect the DC power cord, the satellite router may not perform
properly and could be damaged.
•
Observe the power standards and requirements of the country where it is
installed.
If there is any reason to remove power from the satellite router, always unplug
the AC power cord from the power source (power outlet, power strip, or surge
protector). Do not remove the DC power cord from the router’s rear panel.
Doing so could result in an electrical shock or damage the router.
When you re-apply power to the router, plug the AC power cord into the power
source.
NOTICE
CAUTION