HP StorageWorks 300, Руководство пользователя

Страница: 27 / 180

11184
Figure 3 Attaching rails to the VLS300node
2. Align the holes in the rail with the round tabs on the side of the node.
3. Put the rail onto the node with the tabs extending into the holes on the side of the rail, then slide the
rail toward the front of the node until the tabs are locked into the rail.
4. Perform these steps again to Install the other rail on the other side of the node.
Install appliance in rack
1.
Align the rails on the appliance with the rails in the rack.
2. Slide the appliance fully into the rack.
The rails on the appliance will lock into the rails on the rack.
3. With the appliance fully seated in the rack, tighten the thumbscrews just until the node bezel is
secured to the rack.
Install the 100 Mb Ethernet switch 2524 into a rack
To install the 100 Mb Ethernet switch 2524 into the rack:
NOTE:
There are no rails associated with this switch.
1.
If the metal mounting brackets are not attached to the switch, attach them now.
a. Align the brackets so that the four screw holes are against the side of the switch and the side
of the bracket with the single screw hole extends from the switch and aligns with the front of
the bezel. See Figure 4 .
HP StorageWorks
27