HP ProCurve 6120G/XG, Руководство по настройке, Страница: 567 / 662

Troubleshooting
Debug/Syslog Operation
Syntax: [no] logging < syslog-ip-addr > [oobm]
Enables or disables Syslog messaging to the specified IP
address. You can configure up to six addresses. If you
configure an address when none are already configured, this
command enables destination logging (Syslog) and the Event
debug type. Therefore, at a minimum, the switch begins
sending Event Log messages to configured Syslog servers. The
IP-RIP message types will also be sent to the Syslog server(s)
if they are currently enabled as debug types. (Refer to “Debug
Messages” on page C-44.)
For switches that have a separate out-of-band management
(OOBM) port, specifying the
oobm parameter causes logging
traffic to go through the OOBM port. Refer to Appendix G,
“Network Out-of-Band Management” in this guide for more
information on out-of-band management.
no logging
removes all currently configured Syslog logging
destinations from the running configuration.
no logging < syslog-ip-address >
removes only the specified Syslog
logging destination from the running configuration.
If you use the “
no
” form of the command to delete the only
remaining Syslog server address, debug destination logging is
disabled on the switch, but the default Event debug type is not
changed.
Also, removing all configured Syslog destinations with the no
logging
command (or a specified Syslog server destination with
the
no logging < syslog-ip-address >
command) does not delete the
Syslog server IP addresses stored in the startup configuration.
To delete Syslog addresses in the startup configuration, you
must enter a
no logging
command followed by the
write memory
command. To verify the deletion of a Syslog server address,
display the startup configuration by entering the
show config
command.
To block the messages sent to configured Syslog servers from
the currently configured debug message type, enter the
no debug
< debug-type > command. (See “Debug Messages” on page C-44.)
C-49