HP ProCurve 6120G/XG, Руководство по настройке

Страница: 358 / 662

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
1. Configure users in the User Table with the
snmpv3 user
command. To view
the list of configured users, enter the show snmpv3 user command (see
“Adding Users” on page 13-10).
2. Assign users to Security Groups based on their security model with the
snmpv3 group command (see “Assigning Users to Groups” on page 13-12).
C a u t i o n
If you add an SNMPv3 user without authentication and/or privacy to a group
that requires either feature, the user will not be able to access the switch.
Ensure that you add a user with the appropriate security level to an existing
security group.
Adding Users. To configure an SNMPv3 user, you must first add the user
name to the list of known users with the snmpv3 user command.
ProCurve(config)# snmpv3 user NetworkAdmin
ProCurve(config)# snmpv3 user NetworkMgr auth md5 authpass priv privpass
Add user Network Admin with
no authentication or privacy.
Add user Network Mgr with
authentication and privacy. MD5 authentication is enabled and
the password is set to ”authpass”.
Privacy is enabled and the
password is set to “privpass”.
ProCurve(config)# show snmpv3 user
User Name
Status and Counters - SNMP v3 Global Configuration Information
-----------------
initial
NetworkAdmin
Auth. Protocol
--------------
MD5
MD5
Privacy Protocol
----------------
CFB AES-128
CBC-DES
Figure 13-2. Adding SNMPv3 Users and Displaying SNMPv3 Configuration
13-10