HP ProCurve 6120G/XG, Руководство по настройке

Страница: 135 / 662

Switch Memory and Configuration
Using Primary and Secondary Flash Image Options
Syntax: erase flash < primary | secondary >
For example, to erase the software image in primary flash, do the following:
1. First verify that a usable flash image exists in secondary flash. The most
reliable way to ensure this is to reboot the switch from the flash image
you want to retain. For example, if you are planning to erase the primary
image, then first reboot from the secondary image to verify that the
secondary image is present and acceptable for your system:
ProCurve# boot system flash secondary
2. Then erase the software image in the selected flash (in this case, primary):
The prompt shows which flash
location will be erased.
Figure 6-11. Example of Erase Flash Prompt
3. Type y at the prompt to complete the flash erase.
4. Use
show flash
to verify erasure of the selected software flash image
The “
0
” here
shows that
primary flash has
been erased.
Figure 6-12. Example of Show Flash Listing After Erasing Primary Flash
Rebooting the Switch
Operating Notes about Booting
Default Boot Source. The switch reboots from primary flash by default
unless you specify the secondary flash by entering either the boot system flash
[primary | secondary] or boot set-default flash [primary | secondary] command.
Both the
boot
command and the
reload
command will reboot based on how
these options have been selected.
Boot Attempts from an Empty Flash Location. In this case, the switch
aborts the attempt and displays
6-19