HP ProCurve 6120G/XG, Руководство по настройке, Страница: 507 / 662

Monitoring and Analyzing Switch Operation
Traffic Mirroring
This command assigns a mirroring source to a previously
configured mirroring session on a source switch. It specifies the
port and/or trunk source(s) to use, the direction of traffic to
mirror, and the session identifier.
The
no
form of the command removes a mirroring source
assigned to the session, but does not remove the session itself.
This enables you to repurpose a session by removing an
unwanted mirroring source and adding another in its place.
interface < eth-port-list >:
Identifies the port(s) or static
trunk(s), on which to mirror traffic. Use a hyphen for a
range of consecutive ports (
d5-d8
).
Use a comma to
separate non-contiguous interfaces (
d5,d8
).
monitor all < in | out | both >: For the interface specified by
< port-list >
, selects traffic to mirror based on whether the
traffic is entering or leaving the switch on the interface.
in :
Mirror entering traffic.
out :
Mirror exiting traffic
.
both :
Mirror traffic entering or exiting.
(Using
monitor
without mirroring criteria or session
number affects session 1. Refer to “Monitor Command” on
page B-46.)
B-37