Honeywell AlarmNet GSMBR, Инструкция по установке и настройке, Страница: 13 / 64

Section 2: Mounting and Wiring
2-5
LYNXR/LYNXR-EN
CONTROL PANEL
iGSMBR-009-V0
2K EOL
RESISTOR
LRR / AAV
TRIGGER
GND
ZONE INPUT Z1/Z2
2
1
4
5
9
8
TB1
TRANSFORMER
AC INPUT 2
AC INPUT 1
COMMUNICATIONS
MODULE
J1
BATTERY
Figure 2-6. Wiring Zone Z1/Z2 Input for a LYNXR Trigger Output
iGSMBR-010-V0
GND
ZONE INPUT Z1/Z2
2
1
4
5
TB1
TRANSFORMER
AC
AC
2K EOL
RESISTOR
N.C.
N.O.
COMMUNICATIONS
MODULE
J1
BATTERY
Figure 2-7. Wiring Zone Z1/Z2 Input for EOL Supervised N.O./N.C. Triggers
Wiring for Module Fault Relay
If the communications module detects a fault in its operation, it generates a fault output.
This output can be used to trigger a supervised zone in the control panel.
The communications module fault output can be programmed for fail-safe mode (see the
prompt "FLT REL ON Y/N"). In this mode, the fault output from the communications
module is energized to ground unless a fault occurs.
To sense a module's fault at the control panel, make connections as shown in
Figure 2-8 ,
using the proper EOL resistor required by the control panel.
NOTE: A 24 hour supervisory zone may be assigned on the control panel to monitor any
communications module faults.