Hioki MEMORY HiCORDER 8855, Инструкция по эксплуатации

Страница: 41 / 264

21
────────────────────────────────────────────────────
2.6 9018-10, 9132-10 CLAMP ON PROBE Connection
────────────────────────────────────────────────────
DANGER
Clamp-on probe should only be connected to the secondary
side of a breaker, so the breaker can prevent an accident if a
short circuit occurs. Connections should never be made to the
primary side of a breaker, because unrestricted current flow
could cause a serious accident if a short circuit occurs.
Before using the 9018-10, 9132-10 CLAMP ON PROBE, be
certain that you understand the instructions and precautions
in the manual
9018-10
9132-10
NOTE
2.6 9018-10, 9132-10 CLAMP ON PROBE Connection
This instrument measures input voltage, so although current can not be
measured directly, current can be measured by the voltage output from the
HIOKI 9810-10, 9132-10 CLAMP ON PROBEs.
Connect the BNC connector of the CLAMP ON PROBE to the analog input
terminal. For details, refer to "Connecting the Connection cord
(for voltage measurement)" of 2.4.2.
The 8855 will indicate measurement results as voltage.
Using the scaling function, units can be converted to "A" for display. See
Section 5.3.2.
When the clamp-on probe is used for measurement, the measurement
precision will be affected both by the 8855 precision and clamp-on probe
precision ratings. The same is true for cases where other clamps are used.
When using the 9199 CONVERSION ADAPTOR, the 9018, 9132 CLAMP
ON PROBEs can be used.