Hioki MEMORY HiCORDER 8855, Инструкция по эксплуатации

Страница: 223 / 264

APPENDIX 1
────────────────────────────────────────────────────
Appendix 1 Error Messages
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
APPX
ERROR 001: Print paper run out.
Set recording paper.
ERROR 002: Set printer lever. Lower the printer lever.
Warning Message and explanation
WARNING 003: Print paper run out. Set recording paper.
WARNING 004: Set printer lever. Lower the printer lever.
WARNING 005: Invalid. (Shot:CONT.) Set the recording length of other than that of continuous
recording.
WARNING 006: Cannot set. (Time/Div
10ms-200ms).
When the recording length is continuous, the printer cannot
be used.
WARNING 007: Printer is not installed. It can not be printed.
WARNING 010: Mount media. Set the recording media.
WARNING 011: Illegal format.
The recording format is not MS-DOS. It is probably a
double-density floppy disk.
WARNING 012: Write Protected. The media is write-protected. Release the write-protect.
Appendix
Appendix 1 Error Messages
The instrument produces two levels of message to indicate problems. These
are distinguished as follows.
Error messages
The "ERROR" indication appears at the bottom of the screen, followed by
the message. This remains until the cause of the error is removed, or the
STOP
key is pressed.
If the "beep sound" item on the system screen is set to ON, then the beeper
sounds intermittently while the message is displayed.
Error Message and explanation
Warning Messages
The "WARNING" indication is displayed on the bottom line of the screen,
followed by the message, but disappears after a few seconds.
Warning messages also disappear if any key is pressed.
If the "beep sound" item on the system screen is set to ON, then the beeper
sounds once only when the message is displayed.