Hioki MEMORY HiCORDER 8855, Инструкция по эксплуатации

Страница: 161 / 264

141
────────────────────────────────────────────────────
7.1 Numerical Calculation (MEM)
────────────────────────────────────────────────────
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Average value The average value in the waveform data
RMS value The RMS value of the waveform data
Peak The peak-to-peak value of the waveform data
Maximum value The maximum value in the waveform data
Time to maximum
value
The time from the trigger to the maximum value
Minimum value The minimum value in the waveform data
Time to minimum
value
The time from the trigger to the minimum value
Period
The cycle of the waveform signal
Frequency
The frequency of the waveform signal
Rise time
The rise time of the waveform data
Fall time
The fall time of the waveform data
Standard deviation
The standard deviation of the waveform data
Area value
The area enclosed by the zero position and the waveform
signal
X-Y area value The composite X-Y area
Specified level
time
The time from the trigger to the specified level
Pulse width The pulse width of the waveform data
Duty ratio The duty ratio of the waveform signal
Pulse count The pulse count of the waveform data
Four arithmetic
operations
The four basic arithmetic operations of the numerical
calculation results
Flashing cursor
Function
display Meaning
: Increase channel number.
: Decrease channel number.
NOTE
Numerical calculation operations
(5) Set the calculation channel
1. Move the flashing cursor to the position shown
in the figure on the left.
2. Use the function keys or the
JOG
control to
make the selection.
The channels where no modules are installed, a channel that deviates from
the set active channel range and channels for which display/record is set to
"OFF" will not be calculated.
When the XY area value is selected in numerical calculation, channels on
the X and Y axes should be specified. "ALL" cannot be selected.
Even if the display format is not the X-Y screen, the XY area value can be
selected.