PCL 600
Operators Manual
v 2.0
42
Enter the measurements in the ‘Calibrate Active Frame’ dialog
The dialog is the same for all configurations of the PCL 600. The top,
bottom and front of the material vary depending on the cutting direction of
the machine. The diagram below shows the surfaces for a column.
Because this is symmetrical, the TOP surface is determined by the
orientation of all profiles in the cutting cell, which will always be the same.
The ‘Top’ will always be next to the short stroke horizontal clamps.
The measurement of the distance from the torch to the FRONT of the
profile is only possible after entering the TOP and BOTTOM distances. If the deviation between TOP and
BOTTOM is too great you will not be able to enter the FRONT value. If this is the case, press ‘OK’ to
calibrate the TOP and BOTTOM only. Then repeat the calibration procedure from the beginning.
