63
Figure 5-26
Preset No.:
Select preset points.
Stay Time:
Stay time on the Preset.
Speed:
Speed for Cruise.
Del cruise
：
Select the cruise line, click to "del cruise", and complete the
cruise line to remove.
Del all cruise:
After clicking, delete all the set cruise lines.
Instruction
The XVR supports up to 255 preset points, but the actual number of
preset positions is limited by the number of preset points that can be
set by the camera. The maximum number of preset points supported by
different PTZs is not necessarily the same.
5.3.5.7 PTZ Setup
The pan/tilt setting is used to set the dome or pan/tilt parameters of the
analog channel. Before controlling the dome or pan/tilt, please make sure
that the RS-485 control cable between the PTZ decoder and the XVR is
properly connected, and configure the PTZ decoder parameters in the device.
The steps are as follows:
Step 1:
On the menu page, select "Camera →PTZ Setup " to enter the PTZ
Setup interface, as shown in Figure 5-27 below.
Step 2:
Set the pan/tilt parameters of the channel (camera protocol, address,
baud rate, data bit, stop bit, check, etc.).
Step 3:
Click "Apply" to save the settings.
