60
Channel:
Select the channel.
Set area:
Click to enter the regional settings interface, hold down the
left mouse button to select the alarm area, select, the alarm area is gray,
select the gray again to cancel the alarm area settings.
Sensitivity:
Select the appropriate sensitivity (Highest, Higher, High,
Middle, Low, Lower, and Lowest) according to your needs. The default is
“Middle” with a total of 7 sensitivity.
Enable detection:
Check "
" to turn on / off motion detection alarm.
Buzzer alarm:
Check "
" to turn on / off the buzzer alarm function.
Send e-mail:
Check "
" to trigger the alarm, XVR sends an email to
the set mailbox to notify the user..
Record channel:
Check "
" to turn on / off the channel recording
function.
Record time (sec):
Set the duration of each recording when the alarm is
triggered.
Week (Time period1 / Time period2):
The arming period, select the day
of the week, set the time period 1&2, the device will only send mail to
the recipient's mailbox within the set time range.
Copy:
After the channel has been set up, click Copy to apply the setting
to another channel.
Instruction
After setting motion detection to open email notification, click "Main
Menu → Configuration → Network → Email" to enter the email setup
interface to set up the email. When the system sends a linkage alarm
within the set time period, the recipient receives the alarm e-mail.
5.3.5.5 Video loss
On the menu page, select "Camera → Video loss" to enter the video loss
setup interface is displayed, as shown in Figure 5-24. Here, you can set the
corresponding channel when the video is lost when the device makes the
appropriate alarm.
