65
Function
Method of operation
Set parameter of timer
In the state of ON, long press the key
and for 5 seconds to enter.
Check parameters and
change functions (for
debugging)
When the backlight is on, press the key
and for 5 seconds to enter.
Set and cancel child lock Press the key and
for 10 seconds to set or cancel.
ECO(default)
/QUIET/TURBO
In the state of on, press the key to enter, switch by pressing the key
or
, and
confirm by pressing the key
again.
In the state of on, press the key , then swich among ECO ,QUIET and TURBO by pressing
or
key,
finally press key to confrim.If there is no key is pressed for 10 seconds,it will automatically exit and the previous
setting is invalid.
Setting special functions
Press the key and
for 10 seconds to set or cancel child lock. In the state of child lock, all keys are not
available.
Child lock
Press the key
to switch on /off the wired controller.
ON/OFF
In the state of off, press the key
for 15 seconds to enter and press the key for 15 seconds again to exit.
Forced to start pump (for debugging)
When the backlight is on, press the key
and
for 5 seconds to enter into this function’s interface , which is
available under the status of on or off.
(Some functions reserved, if the relevant device is not connected in the system, the relevant function code and
machine number will not participate in the loop.)
Checking parameters and change functions (for debugging)
(1) Press the key or
to switch the function code, category A (Heat exchange unit)/ B (outdoor unit)/ C (indoor
unit-- reserved)/ D (Module control board-- reserved)/ E (slave wired controller -- reserved).
(2) A/B is displayed after the decimal point in the intemedidate temperature display area,function code(00-FF) is
displayed in the lower right corner.00-3F can be viewed and changed,while 40-FF can only be queried.The specific
parameters are displayed in the upper right corner.
(3) Switch the function code by using the or
key. If the fuction code is flashing,which means that it can be
queried and can be changed.And if the function code is still,which means that it can only be queried. When the
function code is flashing, press the key to make the function code still. Meanwhile, the parameter value flashes
to indicate that it can be changed. You can adjust the value by the
or
key. After adjustment, press the
key again and the parameter value will not flash. And the function code flashes, indicating that the previous layer
operation is returned. If there is no operation for over 10 seconds, or press the SET key in the state of viewing the
parameter (when function code is 40-7F), exit the parameter viewing and setting interface. And you can also exit
this interface by pressing on/off key.
Содержание AU082FYCRA(HW)
