107
Programming Worksheet
5.
Configure DATA LOGGING for each desired channel:
6.
Configure Flow Totalizer:
Scaling: _________________ (X, X1, X10, X100.... X1,000,000)
Flow Units (Acre-feet, cubic feet, gallons, liters, cubic meters):_________
7.
Configure SETPOINT SAMPLING if it is desired to trigger a sampler based on one of
the following conditions:
Channel Name
Analog Channel Signal Description
Logged (Y/N)
Units
Logging Interval (min)
Process Temperature
Rainfall
pH
Level / Flow
Analog Channel 1
Analog Channel 2
Analog Channel 3
Analog Channel 4
Analog Channel 5
Analog Channel 6
Analog Channel 7
Channel Name
High Trigger
Low Trigger
Deadband
Time Interval
Level
Flow
Flow Rate of Change
pH
Temperature
Rainfall
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Содержание Sigma 950
