106
Programming Worksheet
Applies to velocity models only:
8.
Enter the VELOCITY DIRECTION (Upstream (normal), Downstream or Always
Positive):__________
9.
Enter the VELOCITY UNITS (fps or m/s):__________
10.
Enter the VELOCITY CUTOFF:
11.
Cutoff value = ______________, Default Value = ______________
OPTIONS MENU
From the Main Menu, select
OPTIONS
.
1.
Set Time & Date: __________
2.
Level Sensor (Ultrasonic or Submerged Sensor): __________________
ADVANCED OPTIONS MENU
From the Main Menu, select
OPTIONS
> ADVANCED OPTIONS
.
1.
Setup 4–20 ma Outputs (if desired):__________
2.
Setup ALARMS (if desired):__________
3.
Calibrate inputs (as needed): __________chk
4.
Communications Setup: (If modem is enabled) ACCEPT any baud rate displayed.
[Modem will independently establish actual baud rate between 1200 and 14,400.]
Pager Phone Numbers (if enabled): Pager Service:_____________
Pager #1: ___________ Pager #2: ___________ Pager #3: ___________
Select Baud Rate for RS232 (1200, 2400, 4800, 9600, 19200):_________
Alarm Name
High Trigger
Low Trigger
Deadband
Time Interval
Relay # Set
Low Mem Battery
Level
Flow
Flow Rate of Change
pH
Temperature
Rainfall
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Содержание Sigma 950
