61
Communications Setup
1.
Press
CHANGE CHOICE
to enable the Pager Option. Press the
ACCEPT
.
2.
Enter the phone number of the paging service. If this number is unknown it can
usually be obtained by contacting the pager service's technical support department.
Press
ACCEPT
.
3.
Enter the number of pagers to call when an alarm occurs. The 950 Flow Meter will
support up to 3 pagers. Press
ACCEPT
.
4.
Enter the phone numbers of the individual pagers that the message will be sent to.
These numbers are usually provided when the pager is purchased. Press
ACCEPT
.
8.2.3.2 Reporting Devices
You have the choice of which communication devices will report and in what order.
Choices are
MODEM ONLY, PAGER ONLY, PAGER THEN MODEM, and MODEM THEN
PAGER
.
11:00 AM 21 - APR - 01
MODEM SETUP
ACCEPT
CHANGE
CHOICE
PAGER OPTION:
CANCEL
ENABLED
CHOICES: ENABLED, DISABLED
11:00 AM 21 - APR - 01
MODEM SETUP
ACCEPT
PAGER SERVICE
PHONE NUMBER:
CANCEL
555-5555
CLEAR
ENTRY
(USE NUMERIC KEYPAD)
11:00 AM 21 - APR - 01
MODEM SETUP
ACCEPT
NUMBER OF PAGERS:
CANCEL
3
CLEAR
ENTRY
ENTER 1 - 3
11:00 AM 21 - APR - 01
MODEM SETUP
ACCEPT
PAGER #1
CHANGE
CHOICE
PHONE NUMBER:
CANCEL
555-5555
CHOICES: ENABLED, DISABLED
Содержание Sigma 950
